Estimation of growth rate in unidirectionally solidified multicrystalline silicon by the growth-induced striation method

Multicrystalline silicon was grown by unidirectional solidification method using the accelerated crucible rotation technique. The application of the accelerated crucible rotation technique in unidirectional solidification method induced growth striations across the axial direction of the grown crystal. This striation pattern was observed from carbon concentration distribution, obtained by using Fourier transform infrared spectroscopy. The generated striation pattern was found to be weak and discontinuous. Some striations were absent, probably due to back melting, caused during each crucible rotation. From the growth striations and applied time period in crucible rotation, the growth rate was estimated by using Fourier transformation analysis.     

Integral Representations,Differentiability Properties and Limits at Infinity for Beppo Levi Functions

The first aim in the present paper is to give an integral representation for Beppo Levi functions on R ⁿ. Our integral representation is an extension of Sobolev's integral representation given for infinitely differentiable functions with compact support. As applications, continuity and differentiability properties of Beppo Levi functions are studied.Our second aim in this paper is to study the existence of limits at infinity for Beppo Levi functions. We also consider the existence of fine-type limits at infinity with respect to Bessel capacities, which yields the radial limit result at infinity.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

Anisotropic giant magnetoresistance originating from the π-d interaction in a molecule

We synthesized TPP[Fe^III(Pc)(CN)₂]₂, PTMA_x[Fe^III(Pc)(CN)₂]·y(MeCN), and PXX [Fe^III(Pc)(CN)₂], a new series of charge-transfer salts containing the axially-substituted phthalocyanine (Pc), [Fe^III(Pc)(CN)₂]⁻. In this molecular unit, the π conduction electron derived from the Pc-ring coexists with the d electron which is a potential source of a local magnetic moment. Therefore various phenomena associated with the interplay between local magnetic moments and conduction electrons are expected. We observed the giant negative magnetoresistance (GNMR) in all the three salts. The GNMR is highly anisotropic for the magnetic-field direction, and reflects the g-tensor anisotropy of the local magnetic moment in the [Fe^III(Pc)(CN)₂]⁻ unit. This indicates that the GNMR in these salts originates from the strong π-d interaction in the [Fe^III(Pc)(CN)₂]⁻ unit.     

Hydrolysis of acetals in water under hydrothermal conditions

A simple method for the hydrolysis of acetals and ketals was accomplished in neutral water or aqueous media by hydrothermal treatment without using acidic reagents. The deacetalization reaction was effectively accelerated in the presence of calcium chloride. Because no acidic catalysts were employed, neutralization of the reaction mixture was not necessary after the reaction. This sequence was successfully applied to the hydrolysis of chitosan, a biodegradable polyaminosaccharide.     

Collection of iron(III) from homogeneous aqueous solutions on membrane filters using Chromazurol B with Triton X-100.

A membrane filtration method was examined concerning the effective collection of iron(III) from a homogeneous aqueous solution with Chromazurol B (CAB), one of the triphenylmethane dyes, as a precipitating reagent in the presence of a non-ionic surfactant, polyethylene glycol mono[4-(1,1,3,3-tetramethylbutyl)phenyl]ether (Triton X-100). A formed blue Fe(III)-CAB complex was collected as a precipitate on a membrane filter by filtration under suction from a homogeneous aqueous solution in the pH range over about 2. The original solution was prepared at a concentration ratio of CAB to Fe(III) of to 10, and that of Triton X-100 to CAB of 10 to 100. It was then adjusted to a pH value of between 1.0 and 6.5. A linear relationship (r = 0.999) was obtained between the initial concentration and the found one of Fe(III) in the range of 2.0 x 10(-5) to 4.0 x 10(-4) mol dm(-3) at a fixed concentration ratio of CAB to Fe(III) of 3 and that of Triton X-100 to CAB of 20. This membrane filtration with CAB and Triton X-100 may be utilized for the separation of Fe(III) as a background species.     

Argon sorption and partial molar volume in poly(ethyl methacrylate) above and below the glass transition temperature

Sorption and dilation isotherms for argon in poly(ethyl methacrylate) (PEMA) are reported for pressures up to 50 atm over the temperature range 5–85°C. At temperatures below the glass transition (T_g=61°C), sorption isotherms are well described by the dual-mode sorption model; and isotherms above T_g follow Henry's law. However, isotherms for dilation due to sorption are linear in pressure at all temperatures over the range investigated. Partial molar volumes of Ar in PEMA are obtained from these isotherms. The volumes are approximately constant above T_g (about 40 cm³/mol), whereas the volumes below T_g are smaller and dependent on both temperature and concentration (19–26 cm³/mol). By analyzing the experimental data according to the dual-mode sorption and dilation model, the volume occupied by a dissolved Ar molecule and the mean size of microvoid in the glass are estimated to be 67 129 ų, respectively. The cohesive energy density of the polymer is also estimated as 61 cal/cm³ from the temperature dependence of the dual-mode parameters.     

Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

Approximate controllability for trajectories of semilinear control systems

We treat an abstract semilinear control system and study the controllability problem for its trajectories. Assuming a range condition of the control action operator and an inequality condition on the system parameters, we can show that the reachable trajectory set of the semilinear system is equivalent to that of its corresponding linear system.The author wishes to express his deep appreciation to Prof. T. I. Seidman for his many helpful suggestions and to Prof. W. Takahashi for many stimulating conversations.     

Weak noncovalent Si···F?C interactions stabilized fluoroalkylated rod-like polysilanes as ultrasensitive chemosensors

Noncovalent interactions, such as hydrogen bonding, metal coordination, and π-π stacking, are increasingly being utilized to develop well-ordered and self-organized supramolecular materials. Recently, new types of nonclassical weak interactions, such as C H···π, C H···F C, and C H···O, have been exploited in stabilizing the specific conformations of molecules and molecular assemblies in the solid state. These noncovalent interactions play an important role in materials comprised of polymer chains, because cooperative effects from a large number of weak interactions can lead to drastic changes in its conformation, several properties, and functionalities. The programmed design of synthetic helical polymer with well-defined molecular conformation has been the main subject in modern polymer science and engineering. Silicon-catenated polysilane is an ideal helical silicon quantum wire and polymers with unique photophysical properties. The present review highlights the spectroscopic evidences for through-space weak Si···F C interaction in poly(methyl-3,3,3-trifluoropropylsilane) ( 1 ) in noncoordinating and coordinating solvents by means of NMR (²⁹Si and ¹⁹F) and IR spectroscopies, and viscometric measurement. It was found that 1 is applicable for chemosensors with an extremely high sensitivity and selectivity toward fluoride ions in tetrahydrofuran (THF) and with high sensitivity for nitroaromatic compounds, detected by a decrease in the photoluminescence intensity in THF and in thin solid film. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5060–5075, 2006